• Support
  • Articles
  • Resources
  • Products
Search Support Forums

Search found 6 matches

Search found 6 matchesPage 1 of 1

by yogeshk
Sun May 07, 2017 8:46 pm
Forum: Tera Term Macro Syntax and Usage (questions)
Topic: Automating firmware upgrade/transfer using Tera Term ymodem interface.
Replies: 5
Views: 415
Thanks once again Trevor for taking the time to respond. That helped a lot, it works much more better now.

Thanks,
Yogesh
by yogeshk
Sat May 06, 2017 7:08 pm
Forum: Tera Term Macro Syntax and Usage (questions)
Topic: Automating firmware upgrade/transfer using Tera Term ymodem interface.
Replies: 5
Views: 415
One of the issues I am facing is that timing the reset of the micro-controller and sending the carriage return characters and then ensuring that the bootloader prompt shows up and then send the " upgrade ymodem " command. Currently I am doing it a crude way based on a counter once the rese...
by yogeshk
Sat May 06, 2017 6:19 pm
Forum: Tera Term Macro Syntax and Usage (questions)
Topic: Automating firmware upgrade/transfer using Tera Term ymodem interface.
Replies: 5
Views: 415
Thanks a lot Trevor for taking the time to respond. I will give that a shot. After the upgrade ymodem command, I usually immediately try to begin the transfer.

Thanks,
Yogesh
by yogeshk
Sat May 06, 2017 5:18 pm
Forum: Tera Term Macro Syntax and Usage (questions)
Topic: Automating firmware upgrade/transfer using Tera Term ymodem interface.
Replies: 5
Views: 415
I was wondering if I can get some advice on how best to achieve the same with a Macro, that I can do via the Tera Term UI to transfer fimrware to a micro controller using the ymodem file send interface. Currently here is what I need to do via the Tera Term UI to upgrade the firmware on an existing A...
by yogeshk
Sat May 06, 2017 6:13 am
Forum: Tera Term Macro Syntax and Usage (questions)
Topic: Transmitting a series of hex values or binary data over comm port.
Replies: 1
Views: 231
Figured that out, found an old forum article, to just switch the language to English and it worked.

Thanks,
Yogesh
by yogeshk
Sat May 06, 2017 5:49 am
Forum: Tera Term Macro Syntax and Usage (questions)
Topic: Transmitting a series of hex values or binary data over comm port.
Replies: 1
Views: 231
I am aware that I could transmit a string via the "send" command, however I am not sure how do I transmit an equivalent of a binary buffer via COMM port. so basically as an example I am trying to transmit the data buffer say an array of hex values [0x10, 0xFD, 0x0D] over the comm port. Eve...
Display posts from previous:
Sort by:

Search found 6 matchesPage 1 of 1

cron